Quickprime (T.K Products)
Quickprime is designed to clean and prime the EPDM membrane prior to application of Quickseam products.
Surfaces to be primed must be clean, dry and free of foreign materials, talc and dirt. Pre-cleaning with Splice Wash may be required. Stir Quickprime Plus thoroughly before and during use. When exposed to lower temperatures for a prolonged period of time, restore to room temperature prior to use. Pour the required amount of Quickprime into a bucket for ease of application.
Apply Quickprime to the EPDM membrane with a Quickscrubber Pad and Handle, using long back and forth strokes with moderate to heavy pressure along the length of the area. Continue until surfaces become dark grey in colour (no streaking or puddling). Factory seams require parallel as well as perpendicular application motions along the factory seam. Allow the primed surfaces to dry completely according to the touch-push test (usually less than 10 minutes) before applying Quickseam products (3" seam tape, 6" batten cover strip, 9" formflash etc)
Thinning is not allowed. The following coverage rates can be achieved Per Litre of Quickprime
Standard seam with 3" seam tape = 15lm - 2 sides
">6" batten cover strip = 8lm - 1 side
">5" Flashing Tape = 10lm - 1 side
9" Formflash = 4lm - 1 side
RPF Strip = 15lm - 1 side
RMA Strip = 15lm - 1 side
Flammable, keep away from sources of ignition. Do not smoke when using. For professional use only. Use only in well ventilated areas. Avoid contact with skin and eyes. Keep out of reach of children.
Store in original containers at temperatures between 15 - 25 degrees. Keep the material out of direct sunlight until ready for application.
Shelf life - 12 months, when stored in above mentioned conditions, shelf life will be reduced if exposed to higher temperatures.
Write a reviewYour Name:
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: